Analysis of immune response: comparison of immunoblots after isoelectric focusing and sodium dodecyl sulfate-polyacrylamide gel electrophoresis using cytoplasmic protein extract from Brucella

Analysis of the immune response towards the facultative intracellular bacterium, Brucella melitensis, was studied by immunoblotting after either isoelectric focusing (IEF) or sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE). A cytoplasmic extract (CPE) of Brucella melitensis was used as antigen to analyse the response in 17 sera from naturally infected goats. CPE analysed by IEF exhibited 25 proteins within the pH range of 4.35 to 6. Immunoblotting revealed most of the stained bands around pH 4.5-5.4. CPE analysed by SDS-PAGE showed more than 20 silver stained proteins in the molecular range of 16-18 kDa to 70 kDa but immunoblotting revealed only 1 to 6 bands according to the sera tested. Because proteins are preserved in their native state with IEF, in contrast to SDS-PAGE treatment, this technique may be best suited for analysis of the overall response to natural infection.     

A new method for cell permeabilization reveals a cytosolic protein requirement for Ca2+ -activated secretion in GH3 pituitary cells

Ca2+ is a major regulator of exocytosis in secretory cells, however, the biochemical mechanisms underlying regulation remain to be identified. To render the secretory apparatus accessible for biochemical studies, we have developed a cell permeabilization method (cell cracking) which utilizes mechanical shear. GH3 pituitary cells subjected to cracking were permeable to macromolecules but retained a normal cytoplasmic ultrastructure including secretory granules. Incubation of the permeable cells at 30-37 degrees C with 0.1-1.0 microM Ca2+ and millimolar MgATP resulted in the release of the secretory proteins, prolactin (PRL) and a proteoglycan, but not lysosomal enzymes. Extensively washed permeable cells were incapable of releasing PRL in response to Ca2+ and MgATP addition. However, addition of cytosol was found to restore Ca2+-activated, MgATP-dependent PRL release. The cytosolic factor responsible for activity was thermolabile and protease sensitive. The protein was partially purified, and its molecular mass was estimated to be equivalent to that of a globular protein of 200-350 kDa by molecular sieve chromatography. Inhibitors of calmodulin or protein kinase C (trifluroperazine, calmidazolium, H-7) failed to inhibit Ca2+-activated PRL release, and the required cytosolic protein could not be replaced by purified calmodulin, calmodulin-dependent protein kinase II, protein kinase C, or calpactin I. Further purification and characterization of the cytosolic protein should reveal the nature of biochemical events involved in regulated secretory exocytosis.     

Validity of an ultra-wideband local positioning system to assess specific movements in handball

The aim of this study was to examine the concurrent validity of the Kinexon local positioning system (LPS) in comparison with the Vicon motion capture system used as the reference. Five recreationally active men performed ten repetitions of linear sprints, medio-lateral side-to-side and handball-specific movements both in the centre and on the side of an indoor field. Validity was assessed for peak speed, peak acceleration and peak deceleration using standardised biases, Pearson coefficient of correlation (r), and standardised typical error of the estimate. With the exception of peak decelerations during specific movements in the centre and peak acceleration and deceleration during linear sprints on the side of the field, the standardised typical error of the estimate (TEE) values were all small to moderate (0.06–0.48), standardised bias ranged between 0.01 and 2.85 and Pearson coefficient values were all > 0.90 for all variables in all conditions. Peak acceleration and deceleration during linear sprints on the side of the field showed the largest TEEs and the greatest differences between the two systems. The ultra-wideband based (UWB) local positioning system had acceptable validity compared with Vicon to assess players’ movements in handball with the exception of high accelerations and decelerations during linear sprints on the side of the field.     

Honeybees establish specific sites on the comb for their waggle dances

Successful honeybee foragers perform dances on the surface of the comb where they interact with nectar receivers and dance followers. We have recorded the sites at which dances take place in large ten-frame hives and in two-frame observation hives. We find that dancing bees are most commonly found on particular combs in large hives and in particular areas on the combs in the observation hives. Although the site where dances take place may change from day to day, dancers will keep to the same site during the foraging period in any one day. Furthermore, if an established dance site is artificially relocated in the hive during the day, dancers seek these sites out before commencing their dances. We conclude that the dance sites are labelled in some way and so promote the congregation of both dancers and dance followers at the same site. Accepted: 27 November 1996     

A simulation approach for power calculation in large cohort studies based on multistate models

Realistic power calculations for large cohort studies and nested case control studies are essential for successfully answering important and complex research questions in epidemiology and clinical medicine. For this, we provide a methodical framework for general realistic power calculations via simulations that we put into practice by means of an R‐based template. We consider staggered recruitment and individual hazard rates, competing risks, interaction effects, and the misclassification of covariates. The study cohort is assembled with respect to given age‐, gender‐, and community distributions. Nested case‐control analyses with a varying number of controls enable comparisons of power with a full cohort analysis. Time‐to‐event generation under competing risks, including delayed study‐entry times, is realized on the basis of a six‐state Markov model. Incidence rates, prevalence of risk factors and prefixed hazard ratios allow for the assignment of age‐dependent transition rates given in the form of Cox models. These provide the basis for a central simulation‐algorithm, which is used for the generation of sample paths of the underlying time‐inhomogeneous Markov processes. With the inclusion of frailty terms into the Cox models the Markov property is specifically biased. An “individual Markov process given frailty” creates some unobserved heterogeneity between individuals. Different left‐truncation‐ and right‐censoring patterns call for the use of Cox models for data analysis. p‐values are recorded over repeated simulation runs to allow for the desired power calculations. For illustration, we consider scenarios with a “testing” character as well as realistic scenarios. This enables the validation of a correct implementation of theoretical concepts and concrete sample size recommendations against an actual epidemiological background, here given with possible substudy designs within the German National Cohort.